Tag: spaceflight

Based on the data that Philae beamed down prior to going into hibernation, scientists believe the landing site on Comet 67P/C-G is made of a layer of dust 4 to 8 inches thick covering solid ice.

At Philae’s final landing spot, the MUPUS probe recorded a temperature of –153°C close to the floor of the lander’s balcony before it was deployed. Then, after deployment, the sensors near the tip cooled by about 10°C over a period of roughly half an hour. “We think this is either due to radiative transfer of heat to the cold nearby wall seen in the CIVA images or because the probe had been pushed into a cold dust pile,” says Jörg Knollenberg, instrument scientist for MUPUS at DLR.

The probe then started to hammer itself into the subsurface, but was unable to make more than a few millimetres of progress even at the highest power level of the hammer motor. “If we compare the data with laboratory measurements, we think that the probe encountered a hard surface with strength comparable to that of solid ice,” says Tilman Spohn, principal investigator for MUPUS.

Looking at the results of the thermal mapper and the probe together, the team have made the preliminary assessment that the upper layers of the comet’s surface consist of dust of 10–20 cm thickness, overlaying mechanically strong ice or ice and dust mixtures.

In many ways, this result is a testament to the magnificence of science and the industrial revolution. The methods and technology that made it possible for scientists to predict the make up of comets (dirty snowballs) were developed in the period from the 16th to the 19th centuries, hundreds of years before it was even possible to see Comet 67P, no less land on it and sample its surface. And what do we find when we do land there? The data gathered beforehand from far away is confirmed, as precisely as one can imagine.

Update: Another of Philae’s instruments also detected organics on the surface, though the reports so far are very vague.

A close review of a series of Rosetta images has identified Philae’s first landing site, as well as the spacecraft itself as it approached and bounced away.

The second link is especially amazing, as it includes a gif animation of the landing site, showing the before situation, the puff of dust just after impact, and then Philae drifting away with its shadow hitting the surface of the comet.

Despite several attempts to reposition the lander to get more sunlight to its solar panels, Philae went into hibernation on Saturday.

There is still a chance the lander will come back awake, but right now the Rosetta science team considers its mission complete. Meanwhile, Rosetta will continue its flight with Comet 67P/C-G, tracking it closely for the next year as it makes its next close approach to the sun.

Sitting in the shade under a cliff and on its side, engineers have until Saturday to nudge it into brighter territory before Philae’s batteries go dead.

One of Philae’s major scientific goals is to analyse the comet for organic molecules. To do that, the lander must get samples from the comet into several different instruments, named Ptolemy, Cosac and Civa. There are two ways to do this: sniffing and drilling. Sniffing involves opening the instruments to allow molecules from the surface to drift inside. The instruments are already doing this and returning data.

Drilling is much riskier because it could make the lander topple over. Newton’s third law of motion says that for every action there is an equal and opposite reaction. In the minuscule gravity of the comet, any movement on Philae will cause motion. The drill turning one way will make Philae want to turn the other. Pushing down into the surface will push the lander off again. “We don’t want to start drilling and end the mission,” said Bibring.

But the team has decided to operate another moving instrument, named Mupus, on Thursday evening. This could cause Philae to shift, but calculations show that it would be in a direction that could improve the amount of sunlight falling on the probe. A change in angle of only a few degrees could help. A new panoramic image will be taken after the Mupus deployment to see if there has been any movement.

European engineers have released an overall status update on Philae’s generally good condition after its landing on Comet 67P/C-G.

Later on 12 November, after analysing lander telemetry, the Lander Control Centre (in Cologne) and Philae Science, Operations and Navigation Centre (SONC, Toulouse) reported;There were three touchdowns at 15:34, 17:25 and 17:32 UTC; in other words, the lander bounced. The firing of the harpoons did not occur. The primary battery is working properly. The mass memory is working fine (all data acquired until lander loss of signal at 17:59 UTC were transmitted to the orbiter). Systems on board the lander recorded a rotation of the lander after the first touchdown. This is confirmed by ROMAP instrument data, which recorded a rotation around the Z-axis (vertical).

The lander did receive some power from the solar panels on Wall No. 2 (technical description of the lander’s solar walls here), but it appears that parts of the lander were in shadow during the time that last night’s surface telemetry were being transmitted.

An additional update here.

Philae is between a rock and a hard place. More specifically, it’s on its side, one leg sticking up in the air — and in the shadows of a looming crater wall a few meters away. Solar panels are receiving only about 1.5 hours of light a day, when the goal was for 6 or 7 hours per day to recharge the lander’s batteries. Drilling into the subsurface would have to wait until the very end of Philae’s 60 hours of battery life — for fear that it could upset the lander. Yet mission leaders were largely upbeat about being alive and doing science. Most of the lander’s 10 instruments were taking data, and engineers were exploring options to use the spring of the lander legs or other ground-poking instruments to jostle the lander into a more favorable position.

Even more here, including the first image from the surface.